Ursine dildo project

[Steph]

Started working on this thing. Has an insertible length of 22 cm (11 inches) and a peak diameter of around 5-6 cm (2-2.5 inches). Just a few finishing touches and I can start working on the mold. Pictures in the google drive link.
https://drive.google.com/drive/folders/1fSNRtC6xWuzgOVq--toGkv3wk17NlHgi?usp=drive_link

 

[Steph]

Alright it's done. I decided to try my hand at making tha hardness vary from tip to base again. I poured 2 colours, red for the A10 silicone and black for the A20. It also has a suction cup and a fitting for a bullet vibrator. I should say that the cup goes a little too deep so a bit of the shaft at the bottom is hollow, though that doesn't seem like a problem from what I can tell. It cost around 50 Euros to make. I have no plans to use it and if anyone wants it just contact me and we can discuss it. Shipping shouln't be more than 40 Euros. Pictures have been added to the previous link.